Lay a ruler or other flat straight object on the floor surface and put the level on top to confirm the levelness of the floor surface. Check the levelness of the floor surface, but if there is a continuous slope, then adjust the angle of millimeter wave radar so it is parallel to the floor surface. When the millimeter wave radar is adjusted on a floor surface that has more than one degree of horizontal slope (drainage slope), the radar aiming cannot be adjusted correctly. If the vehicle you are aiming was involved in a collision or if you suspect the alignment is out of specifications, you must perform a wheel alignment prior to aiming the millimeter wave radar-Īiming should be on level ground in a wide open space to avoid errors caused by reflecting objects-Īmount of space require in front of the vehicle:10 m (33 ft) measured from the front bumper4 m (13 ft) in width1.5 m (4.9 ft) in height, measured from the floor Millimeter Wave Radar Aiming Incomplete: DTC P2583-54 However, if you have the following DTC, proceed with the aiming procedure. If the DTCs are not repaired, you cannot complete the millimeter wave radar aiming procedure. If DTCs are indicated, do the indicated DTCs first. The millimeter wave radar has a self-diagnosis function and if the mounting angle of the millimeter wave radar is outside of the horizontal auto-aiming range, it stores the failure information. The ACC indicator comes on if the aiming process is not completed correctly. The millimeter wave radar must be re-aimed if the millimeter wave radar is removed or replaced. * (SPX 10243): Available through the Honda Tool and Equipment Program 88* (07AAJ-STKA220/07AAJ-TK8A100/07AAJ-STKA200): Stand 07AAJ-TK8A100 with Reflector Set 07AAJ-STKA200 or Stand Set 07AAJ-STKA220 can be used for aiming. Special Tools RequiredImageDescription/Tool NumberStand Set 07AAJ-STKA220*Stand 07AAJ-TK8A100*Reflector Set 07AAJ-STKA200*Alignment Set 07AAJ-STKA210Adaptive Speed Control Alignment Tool SPX 10243*